Access inserted photo cards on supported HPLIP printers. This provides an alternative for older devices that do not support USB mass storage or for access to photo cards over a network.
Usage: hp-unload [PRINTER|DEVICE-URI] [MODE] [OPTIONS]
[PRINTER|DEVICE-URI] (See Notes)
| To specify a device-URI: |
-d<device-uri> or --device=<device-uri> |
| To specify a CUPS printer: |
-p<printer> or --printer=<printer> |
[MODE]
| Enter interactive mode (ftp-like interface): |
-i or --interactive |
| Enter graphical UI mode: |
-u or --gui (Default) |
| Run in non-interactive mode (batch mode): |
-n or --non-interactive |
[OPTIONS]
| Output directory: |
-o<dir> or --output=<dir> (Defaults to current directory)(Only used for non-GUI modes) |
| Bus to probe (if device not specified): |
-b<bus> or --bus=<bus> |
| |
<bus>: cups*, usb*, net, bt, fw, par* (*defaults) (Note: bt and fw not supported in this release.) |
| Set the logging level: |
-l<level> or --logging=<level> |
| |
<level>: none, info*, error, warn, debug (*default) |
| Run in debug mode: |
-g (same as option: -ldebug) |
| This help information: |
-h or --help |
Notes:
- If device or printer is not specified, the local device bus is probed and the program enters interactive mode.
|
- If -p* is specified, the default CUPS printer will be used.
|
- Use 'help' command at the pcard:> prompt for command help (Interactive mode (-i) only).
|
Last update: Tue Aug 1 13:42:02 2006
| 
